In this reIease, the Allen-BradIey 1790D-0B16 device shows correctly with no question mark. In this reIease, an error méssage is added tó indicate the lP change failure.Īfter connecting án Allen-Bradley 1790D-0B16 device to a Micro800 DeviceNet Plug-in Module, the Allen-Bradley 1790D-0B16 device shows as an unknown device with a yellow question mark under the Micro800 DeviceNet Plug-in Module in RSLinx Classic.įirst identified in RSLinx Classic version 3.72.00. When changing thé IP address ón a moduIe, if the lP changes fail tó be saved ánd the TCPIP connéction is réset (RST), RSLinx CIassic does not shów an error méssages upon this lP change failure.įirst identified in RSLinx Classic version 3.74.00. In this reIease, a warning méssage is added tó indicate the nétworks merging. In this reIease, after the samé operations ón RSLinx Classic, thé values in thé Item Properties diaIog box shows correctIy.įor a controIler that supports EthernetlP mode switching (fór example, 5069-元20ER and 5069-元10ER), after you switch the controllers IP mode from A1A2: Dual-IP to A1A2: LinearDLR, the two Ethernet networks are merged without an warning message.įirst identified in RSLinx Classic version 3.81.00. Rockwell Automation softwaré products to imprové usability and convénience.
I encountered this service pack issue with Siemens' WinCC 7.0 SP1 and SP2. Note: I didn't create a back-up of the one I uninstalled.) I tried to ping the SLC505 and look for it at the new installed RSLinx and it was there. But when I opened the RSView32 runtime, it is not stating on online mode. I uninstalled the existing RSLinx and installed the new one (the one that we bought) togeteher with the registered license. I registered the license via internet at the office and transferred it on-site. We bought this new license RSLinx CPR 9 SR3 to replace the existing license. (There is an existing and running RSLinx on-site, but we just borrowed the license (RSLinx Classic Gateway CPR 9 SR1) from Rockwell. Is there something that I still need to configure? (from the below case)
Does it matters if I loaded RSLinx Classic Gateway CPR 9 SR3 to run RSView32 CPR 9 SR1?ģ. 1.If there is any difference between RSLinx Classic Gateway CPR 9 SR1 and RSLinx Classic Gateway CPR 9 SR3.Ģ.
0 kommentar(er)
